Larger size (30in long) is for T-Post mounted feed blocks- pictured. Keeps opossums and raccoons from accessing your deer feed blocks. Install on t-post directly beneath the feed block base, as close to base as possible, tapered side pointed to ground.
Bird Feeder Slides- Prevent squirrels or other small animals from climbing the support pole of your bird feeder. Works best on 5ft or higher 1/2" diameter Shepard's hook round or square poles. No tools required for installation. You can have it installed and protecting your feeder in less than 10 minutes.
Do not recommend on bird feeder poles shorter than 5ft, squirrels can jump right to the feeder bypassing the pole on these shorter setups.
Installation instructions:
USE GLOVES AS EDGES ARE SHARP!
No tools required, clean pole prior to installation
Before removing backing paper, determine best placement
If your bird view will be observed through a window from inside your home, install the kit with the thinnest side aligned to the window... Squirrel slide virtually disappears.
Recommend top of slider panel installed 54 inches from the ground. Clean pole where kit will be installed. Use a general cleaner and paper towel. Make sure it is clean and wiped dry. **Remove zip tie holding the two panels together.
**Start with the panel with the channel first.
Peel away the backing paper of the channel panel and affix on pole. Without touching the adhesive side, press panel against pole to ensure contact. Peel the red double stick starter tab off the second flat panel which is aluminum and align with the first panel on the pole. Adhesive sides facing each other. Press both firmly together down the center of each panel... USE CAUTION along the edges as they will be sharp. Kit is now installed.
Made in the USA!!
